Send us your boat measurements

1. Download the mounting templates (PDF file)
2. Print out the mounting templates and use them to determine how you will mount the autopilot on your vessel
3. Take photos of your wheel and the area where the autopilot will be installed
4. Send us your measurements using the form below

Contact Information

Name Phone Number Email Address

Vessel Information

Vessel Name Displacement Model Length

Mounting Orientation

The Sensor and Drive boxes normally face aft as shown.
Please indicate if a different orientation is needed.

Wheel Configuration

1 Type of steering system (cable, gear, hydraulic) 2 Number of wheel turns, lock-to-lock
14" wheel adaptor suggested for boats with less than 3 turns lock-to-lock
3 Wheel Diameter 4 Distance from bottom of wheel to deck 5 Number of spokes 6 Spoke diameter

Pedestal Mounting Measurements

Provide these measurements if you are mounting the drive box on a pedestal. 7 Clearance between spokes and pedestal
8 Diameter of pedestal at bracket position 9 Height of pedestal base

Drive Box Mounting Method

10

Bulkhead or console mount L-Bracket mount Pedestal mount

Belt Sizing

11

Use one of the supplied mounting templates to determine the desired distance between the wheel pulley and drive pulley centers:

12" Wheel Adaptor 9" (23cm) 11-3/4" (30cm) 15-3/4" (40cm) 17-1/4" (44cm) 19-1/8" (49cm) 21-1/4" (54cm) 23-1/8" (59cm) 23-3/8" (59cm) 25-1/4" (64cm) 27-3/8" (70cm) 38-1/4" (97cm) 14" Wheel Adaptor 14" (36cm) 15-3/4" (40cm) 17-5/8" (45cm) 19-5/8" (50cm) 21-3/4" (55cm) 22" (56cm) 23-7/8" (61cm) 26" (66cm) 36-1/2" (93cm)
14" wheel adaptor suggested for boats with less than 3 turns lock-to-lock

Photos

Email photos of your installation location to info@cptautopilot.com.

Notes

We can customize your autopilot if there is an unusual mounting situation—just let us know!